Buffalo TS-2RZH NAS driver for Windows 7 - Buffalo TS-2RZH NAS driver from Buffalo for Windo

Buffalo TS-2RZH NAS 2.47

Buffalo TS-2RZH NAS driver from Buffalo for Windows 2003, Windows Vista, Windows 2008, Wi

Buffalo TS-2RZH NAS driver from Buffalo for Windows 2003, Windows Vista, Windows 2008, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows Server 2012, Windows 8.1, Windows 8.1 64 bit, Windows 10, Windows 10 64 bit

Publisher review for Buffalo TS-2RZH NAS 2.47:

Before install Buffalo TS-2RZH NAS 2.47you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Buffalo TS-2RZH NAS . We recommend to always use most recent version of a driver.

Changes: - Fixed a bug where a working hard drive was detected as a failed drive in rare occasions.
Before updating the firmware: - Please consult your local technical support representative if you experience any problems caused by this firmware update.
- Do not turn the unit off until the update is finished. It will take several minutes. You will receive a message when the update is finished.
- USB drives are not mounted automatically after a firmware update. To mount them, unplug and then reconnect them.
How to Use Updater: - Connect the TeraStation properly and configure the TeraStation and a computer to run the updater on the same network subnet. The subnet masks should be the same and the first three numbers of the IP addresses should be the same. The last number of the IP addresses should be different.
- Close all applications. Also, stop or exit any firewall software.
- Extract the downloaded file and run "TSUpdater.exe". When a TeraStation is detected, an update window will open.
- Select the TeraStation to update if multiple TeraStation are connected.
- Click "Update" and enter the TeraStation's admin password.
- Click "OK".
- Transferring and updating the firmware will start. Wait until it finishes. The info LED will blink during the update.
- When the update is complete, a message will be displayed

Operating system:
Windows 2003, Windows Vista, Windows 2008, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows Server 2012, Windows 8.1, Windows 8.1 64 bit, Windows 10, Windows 10